Florida Information · Learning Center

Sheet-Metal Work (1919) | THIS IS FLORIDA

A 1919 self-instruction manual on laying out sheet-metal patterns, with chapters on skylights, tin, copper and galvanized roofing, standing-seam and corrugated roofs, and cornices.

Official-source review: November 21, 2026 · Independent Florida guide

Florida information in plain text. No need to ask AI.

Important: Roof work is a fall hazard, and old soldering and lead methods carry fume and lead hazards. Florida roofs must meet today's Florida Building Code. Old manuals teach fundamentals only.

Quick facts

What it covers

The introduction says the sheet-metal draftsman must understand geometry and the development of surfaces so a form can be made without waste or distortion. The first part covers tools, materials, parallel-line development, triangulation and approximate developments, then workshop problems such as elbows, ventilators, transition pieces, offsets, branches, tanks and boiler stacks, with tables of metal weights and gauges.

The skylight chapter covers bars, curbs, condensation gutters and single-pitch, double-pitch and hipped skylights. The roofing chapter (pages 158 to 190) covers tin, copper and galvanized iron roofs, building paper, roof mensuration, flat-seam roofing, gutters, flashings, sheet lead, soldering, standing-seam roofing and laying corrugated roofing and siding. A final part covers cornice work and miter cutting.

How to use it

Use the roofing chapter to learn how metal roofs are measured, cut, seamed and flashed. Standing-seam and corrugated metal roofs are common in Florida, and the seam and flashing ideas still apply.

Work the pattern development problems with paper and a compass first. They teach the layout skills behind ductwork, gutters and flashing.

Use current manufacturer instructions and code for fastening, because wind uplift ratings did not exist in 1919.

License and how to get it

It was published in the United States in 1919, so it is in the public domain in the U.S. The Internet Archive copy is a Library of Congress scan; its record says the Library of Congress is unaware of any copyright restrictions. THIS IS FLORIDA links to it and does not host a copy.

Safety and currency note

Repair manuals are for learning. Old manuals teach fundamentals; check current practice, codes and the manufacturer's instructions.

Roof work is a fall hazard: use fall protection, stay off wet or steep roofs, and keep clear of power lines. Reroofing and structural roof repairs in Florida must meet the Florida Building Code, and your local building department can tell you which permits apply.

Sheet-metal edges cut; wear gloves and eye protection. Soldering and sheet lead give off fumes and lead dust; work with ventilation and wash hands. Old books may describe lead, asbestos, mercury or toxic chemicals as normal materials. Do not follow old chemical recipes, and treat lead and asbestos work as history, not instructions.

Official source

Reviewed November 21, 2026. The official page below controls if the license, contents or instructions change.

  1. Internet Archive: Sheet-Metal Work (1919), Library of Congress scan

THIS IS FLORIDA is an independent informational resource and is not affiliated with the authors, publishers or projects named on this page. Confirm current details at the official source before acting.